PH261-1/HB

Category:

Manufacturer: MEP

The PH 261-1, manual band sawing machines for cuts from 0° to 60° on the left are also supplied in a version with HB device to make single cuts without operators, still keeping the manual cutting cycle available ( the HB device is available only in the three-phase version)

HB CUTTING CYCLE: After positioning the bar and closing the vice, the cutting phase is started, using the weight of the saw frame controlled by a hydraulic circuit to adjust the downfeed speed; after the cut the band stops, the frame is manually lifted in order to reposition the bar to cut untill the position needed by the operator , at this point the head frame is locked by the manually-controlled hydraulic valve.

  • Sturdy structures in cast iron in order to tension the band at 900 kg.

  • Electrical board with entirely identifiable wiring, stand-by, main switch with lock, short circuit protection, motor overload cutout, min. voltage coil, low voltage system 24 V.

  • Control handle IP55.

  • Driving pulley locked with clamp ring to ensure a strong fastening, still allowing axial adjustment.

  • Blade-guide heads with 6 CARBIDE pads instead of bearings to ensure a better stability.

  • Stop strokes at 0° and 60° on the left with lever for locking at any intermediate angle.

  • Head articulation with preloaded tapered bearings.

  • Vice with fast locking lever.

  • Electric pump for the band lubrication and cooling.

  • Brush band-cleaning device.

  • Bimetallic band for profiles and solid pieces.

PH261-1/HB 1
Close Menu